1. OPERATION
1-8
Referring to operation descriptions in the table below, press W or X to select an
operation, press S or T to select an entry in the list, then press the ENT/ACK key
to confirm the selection.
4. Select [ETA (LT/UTC)], then press the ENT/ACK key. The settings pop up window
shown below appears.
Note 1: The ETA indication appears as "ETA [LT]" when a time offset is set from
[TIME DIFF] in the [USER SET] menu. When the setting for [TIME DIFF] is not
changed from the default (+00:00) setting, the ETA indication appears as "ETA
[UTC]".
Note 2: Where a GPS is not connected, or the signal is lost/interrupted, the ETA
indication appears as ETA [UTC]. Further, the settings pop up window displays
"NOTE: INPUT THE UTC" at the bottom of the pop up window.
5. Set the ETA date and time, referring to the figure above, then press the ENT/ACK
key.
6. Select [CARGO TYPE], then press the ENT/ACK key. The settings pop up win-
dow shown below appears.
7. Select type of vessel/cargo, referring to the table on the following page, then press
the ENT/ACK key.
Note 1: Only the second digit for the type of vessel is entered here; the first digit
is entered on the [INITIAL SET] menu, during installation.
Note 2: When [Tanker] is selected and the Nav status is [Moored], output power
is automatically switched to 1 W when SOG is less than 3 knots. Further, in the
above condition, when SOG becomes higher than 3 knots, a beep sounds. (The
pop-up message "TX POWER CHANGED" also appears to notify you that the Tx
power has changed). To erase the pop-up message, press the ENT/ACK key or
reduce SOG to below 3 knots.
Operation Description
<SET> Set the current selection as the destination.
<EDIT> Rename the selected destination.
<CUT> Cut the current selection to temporary memory, leaving the entry empty.
The destination can now be pasted as a different entry.
<COPY> Copy the current selection to temporary memory. The destination can
now be pasted as a different entry.
<PASTE> Paste the entry in temporary memory.
Note 1: Only one entry can be stored in temporary memory at a time. If
you <CUT> two entries successively, the first is deleted.
Note 2: Entries over-written with <PASTE> cannot be restored.
12 / 10 12:32
ETA (UTC)
ETA month
ETA day
ETA time
in 24hr format
CARGO TYPE
30
FISHING
To Next Page
Loading...
