3. MAINTENANCE, TROUBLESHOOTING
3-8
3.6 GPS Monitor
The GPS monitor display shows information about the built-in GPS receiver, including
position, speed over ground, course over ground, date, time, mode position accuracy,
position-fixing status and RAIM status.
1. Press the MENU/ESC key to open the menu.
2. Select [STATUS], then press the ENT/ACK key.
3. Select [INTERNAL GPS], then press the ENT/ACK key.
4. Press the DISP key to close the display.
Indication Description Indication Description
UTC Date and time MODE Selected GPS mode
• [GPS]: GPS is used for position fix.
• [DGPS]: DGPS is used for position
fix.
• [NO FIX]: The system is unable to cal-
culate a position fix.
LAT Latitude of current position STATUS GPS status
• [2D]: Two dimensional GPS fix.
• [3D]: Three dimensional GPS fix.
• [D2D]: Two dimensional DGPS fix.
• [D3D]: Three dimensional DGPS fix.
• [DOP]: Dilution of precision fix.
• [NO FIX]: The system is unable to cal-
culate a position fix.
LON Longitude of current position PA Position accuracy
(HIGH = Less than 10 m, LOW = more
than 10 m)
SOG Speed Over Ground RAIM Current RAIM status
(USED or UNUSED)
COG Course Over Ground
UTC
LAT
LON
SOG
COG
MODE
STATUS
PA
RAIM
28/NOV/2014 16:26:15
34º44.5000´N
135º21.3000´E
110.9kn
350.0º
DGPS
NO FIX
HIGH
UNUSED
INTERNAL GPS
: BACK
MENU
To Next Page
Loading...
