3. MAINTENANCE, TROUBLESHOOTING
3-9
3.7 Displaying Sensor Status
The [SENSOR STATUS] screen shows currently connected sensors’ status.
1. Press the MENU/ESC key.
2. Select [STATUS], then press the ENT/ACK key.
3. Select [SENSOR STATUS] then press the ENT/ACK key.
4. Press the DISP key to close the display. The table below lists the possible sensor
status messages and their meanings.
Sensor Status Message Meaning
EXTERNAL DGNSS IN USE Using external DGNSS
EXTERNAL GNSS IN USE Using external GNSS
INTERNAL DGNSS IN USE
(BEACON)
Using internal DGNSS beacon
INTERNAL DGNSS IN USE
(MESSAGE 17)
MSG 17 corrects internal GNSS with differential correction
INTERNAL GNSS IN USE Using internal GNSS
EXTERNAL SOG/COG IN USE Using external SOG/COG
INTERNAL SOG/COG IN USE Using internal SOG/COG
HEADING VALID Heading data normal
RATE OF TURN INDICATOR IN USE ROT data normal
OTHER ROT SOURCE IN USE Value calculated from HDT, or ROT device used and talker
is other than TI.
CHANNEL MANAGEMENT
PARAMETERS CHANGED
Channel changed (displayed about 30 s)
SENSOR STATUS
: CURSOR
: BACK
MENU
01 : No. 1 EXTERNAL DGNSS IN USE
02 : No. 4 INTERNAL DGNSS IN USE (MESSAGE 17)
03 : No. 7 INTERNAL SOG / COG IN USE
04 : No. 10 OTHER ROT SOURCE IN USE
SENSOR STATUS 01 /04
To Next Page
Loading...
