2. INLAND AIS OPERATION
2-10
For SAR(VESSEL/AIRCRAFT)/SART/MOB/EPIRB type targets
Note 1: If there is no data for the target selected, the fields are displayed as "=NO
TARGET=".
Note 2: Targets are automatically sorted in range order (closest to farthest) when
no key is operated for 30 seconds. Target order is then updated every five sec-
onds.
Active AIS-SARTs take priority and are displayed at the top of the list.
Note 3: When [AUTO SORT] on the [USER SET] menu is [OFF], the range and
bearing to a target are updated. However, target order is not updated. To manu-
ally sort targets, see step 2.
Note 4: To select a target on the plotter display, press S or T to select the target
then press the ENT/ACK key. Press S to cycle through targets from nearest to
furthest; T to cycle through targets from farthest to nearest.
2. To view target data, or to sort the target list, select the desired target, then press
the ENT/ACK key. The target list options pop up window appears.
• [SORT (NORMAL)]: Press W to display and sort the [TARGET LIST] into range
order. The closest target is displayed at the top of the list.
• [SORT (DANGER)]: Press X to display and sort the [DANGEROUS TARGET
LIST] in range order. The closest target is displayed at the top of the list.
• [VIEW DETAIL]: Press the ENT/ACK key to open the [TARGET DETAIL]
screen.
• [NEW MSG]: Press S to open the text input window to create an AIS message
to the selected target.
• [NAME REQUEST]: Press T to send a name request to the target vessel’s AIS.
Note: Name requests cannot be sent to the same target within a short period,
regardless of target. If you have requested the name of a target too soon after
the last request, or the target is out of range, or the target has set their AIS to
RX only mode, the pop up message "CANNOT REQUEST NAME" is displayed.
Wait a short while before requesting the name again.
3. Press the DISP key to close the menu.
TYPE Display format
SAR Vessel "SAR/VESSEL"
SAR Aircraft "SAR/AIRCRAFT"
SART Active "SART ACTIVE"
SART Test "SART TEST"
MOB Active "MOB ACTIVE"
MOB Test "MOB TEST"
EPIRB Active "EPIRB ACTIVE"
EPIRB Test "EPIRB TEST"
AIS Base Station "BS: (station’s MMSI/name)"
FUNCTION
NEW MSG
VIEW DETAIL SORT
(
DANGER
)
SORT
(
NORMAL
)
NAME REQUEST
ENT
To Next Page
Loading...
