3. ADJUSTMENTS
3-8
3.5.4 [INSTALLATION] menu
Open the main menu then select [RADAR INSTALLATION]o [INSTALLATION] to
open the [INSTALLATION] menu through two pages. On the page 1, select [NEXT] to
open the page 2.
[RANGE UNIT]
For B-type radars, select the range unit, [NM], [SM], [KM] or [kyd] then push the left
button. For the all other radar types, the range unit is fixed at [NM] so this menu is not
shown.
[RADAR No.]
For multiple radar system using the network hub, set number (name) and antenna po-
sition for each system to easily distinguish the radar configuration.
• [1] to [4]: For main radar
• [5] to [8]: For sub radar
[RADAR POSITION]
Select the radar position. The choices are [FORE],[MAIN-TOP], [MAIN-2ND], [MAIN-
3RD], [AFT], [PORT], and [STARBOARD].
[MODEL]
Confirm the model of your radar. This menu is set automatically according to the an-
tenna. If this setting is different from your model, the radar will not function properly.
Note: This menu is not restored after [FACTORY DEFAULT] is run.
• For FAR-2218(-BB)/2318: [12]
• For FAR-2228(-BB)/2328: [25UP]
• For FAR-2328W: [25DOWN]
• For FAR-2238S(-BB)/2338S: [30UP]
• For FAR-2338SW: [30DOWN]
Page 1 Page 2
Only for
B-type radar.
Go to page 2.
Go back to
page 1.
To Next Page
Loading...
