2. WIRING
2-51
4. Pass the cables to the TB board 03P9648 and clamp the shield of the cable with
the cable clamp (A) shown in the following figure. Then, connect to J611 and J612.
Connection of cable of LAN, Monitor Unit, VDR
Connect the cables of Intelligent HUB (HUB-3000) and Switching HUB (HUB-100) to
the LAN ports in front of the processor unit.
Connect the cables of Monitor unit or VDR to the DVI ports at the front of the processor
unit.
For VDR connection, the RGB signal can be output with using the optional DVI-BNC
cable kit OP03-252 (Code No.: 001-496-900).
1. Attach the five connectors of the Cable Assembly (supplied) to the fixing plate
(supplied) with cable ties as below.
2. Establish the ground system on the fixing plate.
3. Fix the cable assembly to the appropriate location with two screw (M5). The loca-
tion must be within 200 cm of the processor unit.
4. Connect the VDR cables to the connectors of the cable assembly.
03P9648
J611 (10 lines)
Control unit cable
J612 (2 lines)
㻷㻱㼅㻮㻻㻭㻾㻰
Clamp the shield.
(
A
)
DVI-I port (for analog signal) DVI-D port (for digital signal)
LAN1 port
(for HUB-3000)
LAN2 port
(for HUB-100)
To Next Page
Loading...
