12
4. Press the [↑] or [↓] key to choose the report number desired and then press the [Enter]
key to display the window shown on the following page.
SSAS Report
ON
Real+Test
TELEX
02:00 (hh: mm)
Status
Mode
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
LES ID
Report Interval
SSAS Report
ON
Real+Test
TELEX/MES
02:00
Status
Mode
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Destination
Modem Type
Address
Subject
LES ID
Report Interval
FELCOM 15/16 FELCOM 18/19
5. Press the [↓] key to choose Mode and then press the [Enter] key.
Real+Test
Real Only
Test Only
6. Press the [↑] or [↓] key to choose mode desired and then press the [Enter] key.
“Mode” defines what SSAS report(s) a station is to receive:
Real+Test: Actual SSAS report and test SSAS report.
Real Only: Actual SSAS report only.
Test Only: Test SSAS report only.
7. Press the [↓] key to choose Station Name and then press the [Enter] key.
8. Press the [↑] or [↓] key to choose appropriate station and then press the [Enter] key.
You may sort the list by group name, station name or communication type as follows:
Group name: Each press of [Ctrl] + [G] sorts the list by group name, ascending or
descending order.
Station name: Each press of [Ctrl] + [N] sorts the list by station name, in ascending or
descending order.
Comm. type: Each press of [Ctrl] + [T] sorts the list by communication type, in
ascending or descending order.
9. Press the [↓] key to choose LES ID and then press the [Enter] key.
10. Press the [↑] or [↓] key to choose LES and then press the [Enter] key.
Note: Change the LES whenever sea area has changed. However, the equipment
automatically searches for an LES with which you can communicate and the SSAS
report is transmitted to that LES.
11. Press the [↓] key to choose Report Interval and then press the [Enter] key.
12. Enter time interval (00:10-99:59) to transmit the SSAS report and then press the [Enter]
key.
13. Press the [Esc] key to open the Update window.
Update
No
Yes
14. Yes is selected; press the [Enter] key to close the SSAS report window.
To Next Page
Loading...
Need help?
General
