6. WEB FUNCTIONS
6-22
Change priority of IP filter screen
Group setting screen (DMZ)
Click [DMZ] on the group setting screen to show the DMZ setting screen. Set the
screen according to your system.
DST. address Enter, edit destination address (IPv4 address).
From address Enter, edit source address (IPv4 address).
Protocol Select protocol (ALL, ICMP, Any, TCP/UDP, TCP/UDP(NAPT)).
• If [Protocol] is [Any], enter the protocol number (1-255).
• If [Protocol] is [TCP/UDP] only, select TCP/UDP, TCP, UDP from
list box. Enter port no. (range: 1-65535).
• If [Protocol] is [TCP/UDP(NAPT)] only, select TCP or UDP, and en-
ter the port numbers for [Dst.] and [From] (range: 1-65535).
Add button Register entered information. The IP filter setting screen appears.
Save button Save entered information. The IP filter setting screen appears.
Cancel button Return to IP filter setting screen.
Item Description
Raise priority. (Right button: inoperative)
Lower priority. (Right button: inoperative)
Apply button Save entered information. Return to the IP filter setting screen.
Cancel button Restore previous IP filter settings.
Item Description
Enable / Disable Check [9] to use DMZ. Not checked in initial setting.
DMZ address Enter DMZ address (IPv4 address).
Apply button Apply settings.
Cancel button Restore previous settings
Item Description
To Next Page
Loading...
Need help?
General
