5. WEB SOFTWARE
5-8
In the above connection list, Standard IP Packet Data Connection Service is
connected first.
• In the [Status] field, "Not connected" changes to "Connected" (displays in
green).
• The display in the [Operation] field changes from "Connect" to "Disconnect".
6. Open the desired application software and begin data communication.
Applications are not limited to only those marked with the P mark (applications
preset at paragraph 6.1.9.) You can use any software that appears after the 2nd
application in the list. For example, when the connection list was as shown above,
Windows Media
®
Player uses the 32 kbps streaming IP packet communication
service and all other applications use the standard IP packet communication ser-
vice.
How to disconnect from the internet
Do the following to disconnect from the internet:
1. Click [Main] in the menu bar.
2. Click [Data connection]. The [Data connection] screen is displayed.
3. Click [Disconnect] for the services to disconnect. When disconnecting, the mes-
sage "Now disconnecting..." is displayed. When disconnected, the message
"***disconnection success." is displayed. (***: Service and application)
Note 1: If you disconnect a service marked with a P mark, all other connected ser-
vices will disconnect.
Note 2: If the disconnection fails, "***disconnection failure." is displayed.
4. Click the [OK] button to close the message. The [Status] field displays "Not Con-
nected", the [Operation] button shows "Connect".
To Next Page
Loading...
Need help?
General
