Furuno FS-1570 - Page 51

2.6 Terminal unit, IB-583
2-26
Note 2) Disconnecting flat cable from J9
To disconnect the flat cable;
1. Release the locking tabs by pushing the tabs toward the cable about 1 mm gently.
Excess force will damage the connector.
2. Pull out the cable.
To connect the cable, reverse the above procedure.
Fig.2.6.5 Flat cable connector, J9
Note 3) Disconnecting flat cable from FDD connecter
To disconnect the flat cable;
1. Release the locking tabs by pushing the tabs toward the cable about 1 mm gently.
Excess force will damage the connector.
2. Pull out the cable.
To connect the cable, reverse the above procedure.
Release tabs.
Fig.2.6.6 FDD connector
1mm
Pushing the release tabs
about 1mm gently.
Flat cable
Pushing with equality power
about 1mm gently.