3-1
3. INITIAL SETTING
After completing the installation, check the all connection before applying the power.
3.1 Performance Check
Receiver
1. Set the unit as follows.
a) Speaker: ON
b) Squelch: OFF
c) AGC: FAST
d) Sensitivity: Max
2. Confirm that a signal can be received on each band. If noise or signal is weak, check
the antenna lead-in section, coaxial cable connection and ground connections.
Transmitter
1. On each band, confirm that the antenna is automatically tuned when the [LOG/TUNE]
key is pressed. Automatic tuning time of the antenna should take no longer than 15
seconds to tune, recheck antenna length.
2. Communicate with the handset, confirming that antenna current (IA) changes with voice
level.
3.2 Manual 2182 kHz Tuning Preset
For safety measure, it is required that 2182 kHz be tunable both automatically and manually.
The setup to enable manual tuning, in the event the antenna tuner system fails, is made
with the DIP switches in the antenna coupler. Call a coast station and tell your situation. Be
sure not to transmit during silent period (00 to 03 min. 30 to 33 min. of every hour).
1. Remove the top cover of the antenna coupler. Set the S1 switch (Coupler Board) to
AUTO.
AUTOMANUAL
Coupler Board
S1
switch
LED
(CR1-
CR8)
(In case of FS-2570,
under the shield plate)
Dip SW S4
DipSW S5
S6
LED (CR9-CR22)
S1 switch on the COUPLER Board
2. Turn the transceiver unit on.
3. Press the [1/RT/2182] key down for two seconds.
To Next Page
Loading...
