4-1
4. OPTION KIT
4.1 DSC Routine Frequency Board
For FS-2570, the W/R Board 05P0734 (option) enables reception of DSC routine
frequencies without the SSB radiotelephone connection. For complete modification, the
whip antenna for DSC routine frequency is necessary.
• Necessary Parts :W/R2 Board Kit, Type :OP05-99, Code No. :005-951-840
Name
Type
Code No. Qty Remarks
W/R Board 05P0734 005-952-060 1
Coaxial plug FM-MP-7 000-108-859 1
Cable assy. with mini-pin L-500 000-146-064 1
Cable assy. with mini-pin L-770 000-138-023 1 Not used
Mounting
1. When using the preamplifier, set J3 on W/R board in the kit to ACTIVE (See previous
page).
2. Open the transceiver unit.
3. Remove the shield cover where the W/R board should be fixed in the transceiver unit.
4. Insert the W/R2 Board (hereafter refered to as “W/R2 Board”) to the position shown
below so that J1 connector on the W/R2 Board mates with to P1201 in the transceiver
unit and fasten it with six screws.
Attach the optional
W/R Board here.
(Refered to as
W/R2 Board)
W/R Board (preset)
J1
FS-2570T, cover opened
5. Insert the mini-pin plug, coming from the coaxial connector ANT W/R2, to J2 on the
W/R2 board.
6. Connect the cable assy with mini-pin between J4 on the W/R2 board and J7 on the
TX-RX board 05P0733.
7. Attach the shield cover which removed at step 3.
To Next Page
Loading...
