3-11
3.4.3 Connection to DMC-5, IC-302-DSC
The above equipment can be connected to the DMC port at the back of the main unit. For
these units, set DIP switches as below.
DMC
Set to RS-422 as follows.
S6 S7
#1 #2 #3 #4 #1 #2 #3 #4
ON ON ON ON OFF OFF OFF OFF
IC-302-DSC
Set to Current Loop for IC-302 connection.
S6 S7
#1 #2 #3 #4 #1 #2 #3 #4
OFF OFF OFF OFF ON ON ON ON
3.5 Preamp Setting (For FAX-5)
When using the preamp for the watch receiver antenna, set J3 on the W/R Board to
ACTIVE in the transceiver unit.
J2
J3
ACTIVE
ACTIVE
RX
05P0734
J1
Change jumper to
ACTIVE position.
J4
W/R Board, 05P0734
To Next Page
Loading...
