3-5
3. Rotate the [ENTER] knob to adjust the indicator bar. Too low a setting stops
transmission of a DSC message because it detects noise on the DSC frequency.
Alternately, too high a setting transmits the DSC message though low signal level is
present on the DSC frequency used.
4. Press the [ENTER] knob to finish.
3.3.5 Regulation setting
Set the regulation to be used.
1. On the System setup menu, rotate the [ENTER] knob to select “REGULATION”.
2. Press the [ENTER] knob.
INTL
RUSSIA
DSC regulation pop-up window.
3. Rotate the [ENTER] knob to select “INTL” or “RUSSIA”.
Only for Russia registry, select “RUSSIA”.
4. Press the [ENTER] knob to finish.
3.3.6 System setup (RT)
1. Press the [1] key to show the radiotelephone screen, and then press the [SETUP] key.
Setup menu
NB : OFF
SQ FREQ : 800 Hz
FAX RX ENABLE : OFF
USER CH
SYSTEM
Setup menu (RT)
2. Rotate the [ENTER] knob to select “SYSTEM”, and then press the [ENTER] knob.
System setup
PROTECTION : ON
System setup menu (RT, protection: on)
To Next Page
Loading...
