Furuno FS-2570 - System Setup; Opening the System Setup Menu (DSC)

3-3
For technician
Please pass on the following information to the customer.
• When the auto tuning circuit is broken, transmission is available by the manual tuning (setting
the S1 switch to MANUAL).
• Do not change the settings of DIP switch in the antenna coupler.
3.3 System Setup
Enter system settings as below after the installation. To prevent accidental transmission of
the distress alert, disconnect the antenna. These settings should be entered by a qualified
technician. Under no circumstances shall the operator enter ship’s ID.
3.3.1 Opening the System Setup menu (DSC)
1. Show the DSC standby screen by pressing the [6] key if the screen is not already shown.
Press [SETUP] key to display the Setup menu.
Setup menu
ALARM
AUTO ACK
ERASE
PRINT OUT
MESSAGE
SCAN FREQ
POSITION
VOLUME
TEST
SYSTEM
Setup menu
2. Rotate [ENTER] knob to select “SYSTEM”.
3. Press the [ENTER] knob to display the System setup menu.
System Setup
MMSI :
LINE OUT : +0.0
DB
PROTECTION : ON
WATCH RCVR : MF/HF
CH DET S LEVEL : 100
REGULATION : INTL
PANEL 1 2002-07-24 07:21:43
System setup menu (Protection: on)
4. Enter the password referring to appropriate FURUNO INFORMATION.
System Setup
MMSI :
LINE OUT : +0.0
DB
PROTECTION : OFF
WATCH RCVR : MF/HF
CH DET S LEVEL : 100
REGULATION : INTL
System setup menu (Protection: off)