3-4
3.3.2 Line out level for DSC signal setting
Set line out level. For FURUNO SSB (600 Ω), set 0 dBm.
1. On the System setup menu, rotate the [ENTER] knob to select “LINE OUT”.
2. Press the [ENTER] knob.
LEVEL (-4.5 ~ +4.5) DBM
+00.0
Line out level pop-up window
3. Rotate the [ENTER] knob to adjust the indicator bar (1.5 dBm step).
4. Press the [ENTER] knob to finish.
3.3.3 Watch receiver frequency band
Set the watch receiver function as below.
1. On the System setup menu, rotate the [ENTER] knob to select “WATCH RCVR”.
2. Press the [ENTER] knob to display the pop-up window.
MF/HF
MF
Watch receiver pop-up window
3. Select “MF/HF” or “MF” as appropriate.
MF/HF: Maximum six distress/safety frequencies are available. (A1, A2, A3 and A4 area)
MF: Distress/safety frequency is 2187.5 kHz only (A1 and A2 area)
4. Press the [ENTER] knob to finish.
3.3.4 DSC signal strength
CH DET S LEVEL judges whether the DSC frequency to use to send a DSC message
(Routine and Business only) is in use or not. The DSC message is not transmitted when the
signal strength on the DSC frequency is higher than that set here. When the DSC frequency
becomes clear, the DSC message is automatically transmitted. The setting range is OFF -
250 and the default setting is 100.
1. On the System setup menu, rotate the [ENTER] knob to select “CH DET S LEVEL”.
2. Press the [ENTER] knob to display the CH DET S LEVEL pop-up window.
S LEVEL (OFF 255)
< > 1
CH DET S LEVEL pop-up window
To Next Page
Loading...
