G-1
Appendix G
System messages
G
G.1 Event messages – overview
The FV-110 detects events during
• POST (Power On Self Test) – a self test performed at every power-up.
• PAST (Person Activated Self test) – started in the web interface
• CM (Continuous Monitoring) – automatically performed while the system is in
operation.
When the FV-110 detects an event that requires your action, it issues an event message
and the red Fail/Pass LED in the LED panel of the ACU is lit. As long as an event is
active, it is shown in the ACU display and the web interface (in HELPDESK > Event list
or click the event icon on the DASHBOARD).
State the Event ID when contacting your service partner.
The event description might contain a number of digits in brackets, e.g. (00000005). This
is supplemental information and used for service and diagnostics purposes.
Active events and notifications are shown. As soon as the
event is cleared, it is not displayed any longer. It is then
moved to the Notifications section. Notifications are cleared
after 24 hours.
To Next Page
