Configuration with the web interface
5-28
3. Azimuth: Enter start and stop azimuth value in degrees for the blocking zone. Values
allowed: 0 to 360 degrees. Enter clockwise.
Figure 5-22: Blocking zone, example: 315 - 45 degrees
Figure 5-23: Blocking zone, example: 45 - 315 degrees
4. Elevation: Enter the start and stop elevation angle for the blocking zone. If you enter
nothing, there will be no blocking zone. Values allowed: -90 to 90 degrees.
5. Select No TX for zones if you don’t want the system to transmit.
If not selected, the system also transmits when pointing through areas with blocking
objects. The VSAT modem will shut off for TX if no signal is received.
6. Click Apply to save the blocking zones.
You must enter 2 different elevation angles to have an active blocking zone.
To Next Page
Loading...