ii
SAFETY INSTRUCTIONS,
NOTICES
WARNING
WARNING
Do not open the equipment.
The equipment uses high voltage that
can cause electrical shock. Refer any
repair work to a qualified technician.
If water leaks into the equipment or
something is dropped into the equip-
ment, immediately turn off the power
at the switchboard.
Fire or electrical shock can result.
If the equipment is giving off smoke
or fire, immediately turn off the power
at the switchboard.
Fire or electrical shock can result.
If you feel the equipment is acting
abnormally or giving off strange
noises, immediately turn off the
power at the switchboard and contact
a FURUNO service technician.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury
can result.
Make sure no rain or water splash
leaks into the equipment.
Fire or electrical shock can result if water
leaks into the equipment.
Mandatory Action
Prohibitive Action
WARNING
CAUTION
Warning, Caution
The operator must read the safety instructions before attempting to operate the equipment.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in minor or moderate injury.
WARNING
Do not operate the equipment with
wet hands.
Electrical shock can result.
Use the proper fuse.
Use of the wrong fuse can cause fire or
electrical shock.
In order to prevent problems such as
malfunctions, failures or electrical
leakages from occurring, do not use
this equipment in the following
environments:
- Where the ambient temperature will
go outside the range of -15 to 55˚C.
- Where combustible or flammable
gases are present.
- Where corrosive gases such as
sulfurous acid gas and ammonia are
present.
- Where a lot of dust or iron powders
are present.
- Where organic solvents such as
benzene, thinner and alcohol, or strong
alkaline substances such as ammonia
and caustic soda may adhere to this
equipment, or where they are present.
- Where high-tension lines, high-voltage
equipment, power lines, power-driven
machinery, equipment containing a
transmitter such as a ham radio, or
equipment that generates a large
switching surge are present.
To Next Page
Loading...
