2
1.2 Flush mounting
1. Prepare a cutout in the mounting location using the template sheet (supplied) for the MFD8 or
12.
2. Remove the front panel from the MFD by unfastening the catches at the rear of the panel, in
the order as shown in the figure below.
Note: Catches are tight to unfasten. Take care not to break the panel.
3. Attach the mounting sponge to the display unit.
4. Fix the display unit by using four self-tapping screws (supplied).
5. Attach the front panel to the display unit.
How to detach the front cover from the mounting place.
To detach the front panel after mounting the unit, use the remover (supplied) as below. Note that
the front cover may be damaged if the following is not done.
1. Set the remover to a notch on the lower side of the unit.
Mounting
sponge
Front panel
Cutout
Display unit
(ex. MFD12)
Self-tapping screws
(4 pcs.)
MFD, rear view
(catches’ locations and order to unfasten)
1
2
3
4
5
6
7
1
8
To Next Page
Loading...
Need help?
General
