Furuno TZT2BB - Page 48

3. EQUIPMENT SETUP
3-10
[GRAPHIC INSTRUMENTS SETUP] menu
Maximum and Minimum boat speeds
[DEPTH] menu
[SEA SURFACE TEMPERATURE] menu
[Certification Mark] Displays relevant certification for this equipment.
[Service] Requires login password. For the service technician.
[Event Input Configu-
ration]
Set the function for the event switch. [Off], [Event Mark], [MOB],
[Ferry]
[Set Ext. Monitor IP
Address]
Set IP address of connected monitor. [Not Set], [172.31.26.190] -
[172.31.26.199]
[Remote Controller
Configuration]
When there are multiple units in the NavNet network, the MCU-004 (or
MCU-005) can select the display to show on the unit connected with the Re-
mote Controller.
Further, the cycling order of displays can be set. See the Operator’s Manual
for details.
[Adjust Display Reso-
lution]
Adjusts the output resolution to match the resolution on the connected mon-
itor.
[Event Input Configu-
ration]
Set the function for the event switch. [OFF], [Event Mark], [MOB],
[Ferry]
[Update Network
Equipments]
For the service technician.
[Sirius Radio Diag-
nostic]
Check the satellite radio of the FURUNO BBWX SiriusXM weather receiver
for proper operation. See the Operator’s Manual.
[Sirius Weather Diag-
nostic]
Check the weather section of the FURUNO BBWX SiriusXM weather re-
ceiver for proper operation. See the Operator’s Manual.
[Reset Default Set-
tings]
Reset the system to default settings. [OK], [Cancel]
Menu Item Description Options (setting range)
[Maximum Boat Speed] Set the transducer’s maximum detectable
speed.
1 (kn) to 99 (kn)
[Maximum Wind Speed] Set the transducer’s maximum detectable
speed.
1 (kn) to 99 (kn)
Menu Item Description Options (setting range)
[Minimum Depth] Set the transducer’s minimum detectable
depth.
0 (m) to 1999 (m)
[Maximum Depth] Set the transducer’s maximum detectable
depth.
1 (m) to 2000 (m)
Menu Item Description Options (setting range)
[Minimum Sea Surface
Temperature]
Set the transducer’s minimum detectable
temperature.
0.00°C to 98.99°C
[Maximum Sea Surface
Temperature]
Set the transducer’s maximum detectable
temperature.
0.01°C to 99.99°C
Menu item Description Option (setting range)