1. OPERATION
1-14
• [Extract Period Select] is selected at step 5
The setting window as shown to the fight appears. Use
the cursorpad ( or ) to set the extraction time* (1 to
12 hour(s)) then press the ENT key.
*: Backdated data is extracted, starting from the mo-
ment the ENT key was pressed.
After setting the extraction time, the following window that indicates the extraction
data size and disk space appears.
Note: If the following window appears, check that the USB flash memory is prop-
erly inserted and is formatted to FAT32. Then press the ENT key and restart the
procedure from step 4.
7. Press the ENT key. The confirmation window appears.
8. Use the cursorpad ( or ) to select [Yes] then press the ENT key. The window
changes as follow.
▲
1 hour
▼
(1
~
12) hour
Period Select
Disk space is displayed in red when it is
smaller than extraction data size.
Extract Size
/
Disk S
p
ace
xxx, xxx, xxx, xxx b
y
te
/
xxx, xxx, xxx, xxx b
y
te
Data size* is displayed as an hour even if
object data time is smaller than an hour.
*: “0 byte” may be displayed when the specified extraction period includes the time
zone that does not have recorded data. Even if the data size is “0 byte”, perform
the following steps. The data may be extracted if the recorded data is included in
specified extraction period.
xxxxx: recording
or user
Medium Error!
Check xxxxx Medium
User Disk Format?
Yes
No
During formatting of the USB flash memory
During data extraction Completion of extraction
This window disappears
when pressing the ENT key
with [OK] selected.
Press any key to clear
this window.
Now Formattin
g
Extract Com
p
lete
Now Extractin
g
Remainin
g
time: hh/mm/ss
CancelOK
To Next Page
Loading...
