FUTABA 12K - Page 170

170
<Functions of Model Menu (Helicopter Functions)>
ŏ6HOHFWWKHIXQFWLRQQDPH
DQGUHWXUQWRWKH0RGHO
PHQXE\SXVKLQJWKH RTN
EXWWRQRUSXVKLQJWKH
HOME/EXITEXWWRQ
<Push Dial>
RETURN
MODEL MENU (HELICOPTER)
This section contains information on the
commands that apply to helicopters only. For
instructions on Airplanes and Gliders, refer to the
sections pertaining to those aircraft.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
respective aircraft.
Also, activate/deactivate flight conditions
according to your model. To do so, access at the
Condition Select screen prior to adjusting the
PRGHOVSDUDPHWHUV8SWR¿YHFRQGLWLRQVFDQEH
used)
The Dual Rate function and other functions
FRPPRQWRDOOPRGHOW\SHVKDYHDOUHDG\EHHQ
GHVFULEHGHOVHZKHUHLQWKLVPDQXDO3OHDVHUHIHUWR
these respective sections for information on how to
do so.
Model Menu functions (helicopter) list
PIT CURVE:$GMXVWVSLWFKVHWWLQJVLQGLIIHUHQWÀLJKWFRQGLWLRQV
THR CURVE:7KURWWOHFXUYHDQGKRYHULQJWULPDGMXVWPHQWLQGLIIHUHQWÀLJKWFRQGLWLRQV
THR HOLD: Moves the throttle to idle during autorotation
SWASH MIX:&RPSHQVDWHVFRQWUROUHVSRQVHLQGLIIHUHQWÀLJKWFRQGLWLRQV
THROTTLE MIX: Compensates for power loss when cyclic applied
PIT to NEEDLE:$GMXVWVSLWFKUHVSRQVHLQGLIIHUHQWÀLJKWFRQGLWLRQV
PIT to RUD: Compensates torque changes from pitch angle inputs
GYRO: Used to switch gyro sensitivity
GOVERNOR:8VHGWRVZLWFK530RIWKHKHOLFRSWHU¶VKHDG
6FUROOLQJ
ŏ0RYLQJFXUVRU
ŏ7RQH[WSDJH
ŏ6HOHFWWKHIXQFWLRQ\RX
ZDQWWRVHWDQGDFFHVV
WKHVHWXSVFUHHQE\
SXVKLQJWKH571EXWWRQ
ŏ&DOOWKHPRGHOPHQX VKRZQEHORZE\ORQJ
SXVKLQJWKH0'/EXWWRQDWWKHKRPHVFUHHQ
HWF