FUTABA 12K - Page 42

42
<Basic Operation>
Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver
must be linked with the ID code of the transmitter with which it is being paired. Once the link is made,
the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used
with another transmitter. When you purchase additional R3008SB receivers, this procedure is necessary;
otherwise the receiver will not work.
ůƌƑƎŃƓƕƒƆƈƇƘƕƈŃŷŐũūŶŶŃŤƌƕŃŋŷŔŕŮŒŵŖœœśŶťŌ
1

Place the transmitter and the receiver close
to each other within half (0.5m) meter.
2

Transmitter to link mode.
3

Immediately turn on the receiver power.
The receiver will enter the linking state
(LED blinks red) about 3 seconds after the
receiver power is turned on.
4
If the receiver ID is displayed in the transmitter and the LED changed from red blinking to
a steady green light, linking is complete. (The receiver linking wait state ends in about 3
seconds.)
5

Check system operation. If the transmitter and receiver are not linked, try linking again.
In"Link"Mode
ReceiverON
Callsetupscreen
Tolinkmode
LongPush
PUSH



S
c
r
o
l
l



S
c
r
o
l
l
PUSH
PUSH
Home
CursortotheSYSTEM
CursortotheLINK
PushRTN
PushRTN
LINKAGEMENU
PushDial
Linkmode
Thechimerings.
Releasein10seconds.
NOWLINKING...
When changing
battery fail-safe
voltage from
the initial value
3.8V, voltage is
changed here.
R3008SBOFF
T12KON
Lessthan0.5m
,IWKHUHDUHPDQ\7)+66$LUV\VWHPVWXUQHGRQLQFORVHSUR[LPLW\\RXUUHFHLYHUPLJKWKDYHGLI¿FXOW\HVWDEOLVKLQJDOLQNWR\RXU
transmitter. This is a rare occurrence. However, should another T-FHSS Air transmitter/receiver be linking at the same time,
your receiver could link to the wrong transmitter. This is very dangerous if you do not notice this situation. In order to avoid the
problem,we strongly recommend you to double check whether your receiver is really under control by your transmitter.
*When the linked transmitter power is turned on, communications begins.
*When using 2 receivers, perform the linking operation the same as the 1st receiver. (However, when 2 receivers are used, the
telemetry system cannot be used.)
*Link is required when a new model is made from a model selection.