FUTABA 12K - Page 80

80
<Functions of Linkage Menu>
ŏ6HOHFWWKHIXQFWLRQQDPH
DQGUHWXUQWRWKH/LQNDJH
PHQXE\SXVKLQJWKH RTN
EXWWRQRUSXVKLQJWKH
HOME/EXITEXWWRQ
<Push Dial>
RETURN
System Type selection
The T12K is for 2.4GHz only. The system can be
changed from among 2 choices: T-FHSS Air 14CH
and S-FHSS 8CH.
*If you change the System Type, other model data is not
reset.
*If a system type is changed in helicopter mode, the
transmitter will offer two selections:
[Yes] : Selection sets the channel order suitable for System
Type. (We recommend here. )
[No] : The present channel order is maintained.
*After any change, remember to test the model and should
fully check servo direction and a motion.
SYSTEM
6\VWHPPRGHVHWWLQJ5HFHLYHUOLQN
Battery fail-safe voltage setup (only T-FHSS Air )
The voltage which battery fail-safe activates,
can be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 6.0 ~ 6.2 v
• 2 cells LiPo (Normal: 7.4 v) = 7.2 ~ 7.4 v
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
Receiver linking
The receiver will only be controlled (without
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
Moreover, a re-link is required when a new
model is added by model selection, and the time of
system type change.
ŏ6HOHFW>6<67(0@LQWKH/LQNDJHPHQXDQGDFFHVV
WKHVHWXSVFUHHQVKRZQEHORZE\SXVKLQJWKH
571EXWWRQ
6FUROOLQJ
ŏ0RYLQJFXUVRU
ŏ6HOHFWLQJPRGH
P.42
Linking method
Cases when linking is necessary:
・
:KHQXVLQJDUHFHLYHURWKHUWKDQWKHLQLWLDOVHWWLQJ
・
:KHQWKHFRPPXQLFDWLRQV\VWHPZDVFKDQJHG
7)+66$LU
↔
6)+66
)
・
:KHQDQHZPRGHOZDVFUHDWHGE\PRGHO
VHOHFWLRQ
System Type selection procedure
0RYHWKHFXUVRUWRWKH>7)+66@LWHPDQG
SXVKWKH571EXWWRQWRVZLWFKWRWKHGDWD
LQSXWPRGH
6HOHFWWKHV\VWHPW\SHE\VFUROOLQJWKH3XVK
GLDO
 >7)+66@RU>6)+66@
3XVKWKH571EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVRUPRGH
Telemetry function (T-FHSS Air mode only)
To use the telemetry function, set “Telemetry”
to “ACT”.
ŏ,QWKHFDVHRI7)+66WKH
,'RIWKHOLQNHGUHFHLYHU
LVGLVSOD\HG
System T-FHSS Air S-FHSS
&+ &+212))&+ &+
7HOHPHWU\ 3RVVLEOH ,PSRVVLEOH
5HFHLYHU

56%
56%
56%
5*6
5*)
56%
56%
7KHVXUIDFHV\VWHP
UHFHLYHUVUHFHLYHU
FDQQRWEHXVHG