1414
1414
14
Description Of Functions
Servo Reverse
Steering ATV (Only 2PCKA)
Steering D/R (Only 2PCKA)
This function reverses the rotation direction of the Steering and
Throttle servos.
This function is used to adjust steering travel . The right side
travel and left side travel can be independently adjusted.
This function is used to compensate for any difference in right
or left turning radius or angles due to the characteristics of a
particular model.
Use this function to adjust the steering travel of your
model. If the model understeers (push) while cornering,
add steering by turning the dial clockwise.
When the model oversteers (loose), take away steering
by turning the dial counterclockwise.
When the trim position deviates from the center, the de-
viation will be on the opposite side when the servo is
reversed.
Warning
Operate each servo over its full stroke and check to see
that the linkage does not bind or result in excessive
force being applied to servo.
Excessive force applied to the servo by binding or poor
installation could lead to servo damage as well as loss
of control.
To Next Page
Loading...
Need help?
General
