FUTABA 2PC User Manual

77
77
7
Before Operation
Transmitter T2PC / T2PCKA
Nomenclature / Handling
E.S.C.
MC210CB
MC310CB
High point trim
Neutral point trim
Monitor lamp
Power switch
Connects to Motor
Connects to Battery
Connects to Receiver
ON
OFF
ST.TRIM
TH.TRIM
T2PCKA
DIGITAL PROPORTIONAL
RADIO CONTROL SYSTEM
BATT LEVEL
MID
FULL
RIGHT ST
ST. SERVO
ATV REV SW
LEFT TH
LOW/CHARGE
Antenna
Servo Reversing Switch
(P14)
Steering ATV (P14)
(only T2PCKA)
Trim Panel Cover
Steering Trim (P13)
Steering Wheel
Throttle Trigger
Grip Handle
Steering D/R Dial (P14)
(only T2PCKA)
Power Switch
Battery Level Indicator
Throttle Trim (P13)
*Three LED display to indicate
battery voltage level.
*If the Red led flashes, replace
batteries.
*Open the cover by sliding it
to the left.
*When slid upward, the power is turned on.
*Adjusts the steering in small increments
so the model will run straight.
*Turn model to left or right.
*Adjusts the throttle in small increments
so the model will not move at neutral.
*Control the speed of the model and movement
forward and backward.

FUTABA 2PC Specifications

General

Brand	FUTABA
Model	2PC
Category	Remote Control
Language	English