EasyManua.ls Logo

FUTABA T26SZ - Page 84

FUTABA T26SZ
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
84
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŹƌƈƚƌƑƊŃƗƋƈŃƗƈƏƈƐƈƗƕƜŃƇƄƗƄ
ŷƈƏƈƐƈƗƕƜŃƖƜƖƗƈƐ
Homedisplay
Receivervoltageand
Extvoltagedisplay
This screen displays and sets the various information from the receiver. An alarm and vibration can be
generated depending on the information. For example, a drop in the voltage of the receiver battery housed
in the aircraft can be reported by an alarm.
ThisfunctioncanonlybeusedintheFASSTest26/18CHmodeandT-FHSSAIRmode.TheS-FHSSmodecannotuse
telemetry.
FASSTest12CHmode.Applicablewithreceivervoltagedisplay.
Telemetrysensorssoldseparatelycanbemountedintheaircrafttodisplayavarietyofinformation.(Receivervoltage
doesnotrequireasensor.)
ThetelemetryfunctioncannotbeusedifthetelemetrymodeoftheparametersisnotACT.
FASSTest26/18CH:When3,2receiversareusedwith1transmitter,thetelemetrycannotbeusedforthe3,2receiver.
T-FHSSAIR/FASSTest12CH:When2receiversareusedwith1transmitter,thetelemetryfunctioncannotbeused.When
usingtworeceiverswithFASSTest12ch,useareceiverthathastelemetryOFFmode.
Ifthetransmitterandreceiverarelinked,butthereceiver'sIDisnotrecordedinthetransmitter'smemory,thetelemetry
functioncannotbeused.
Whenthereceivervoltageisturnedoff,thereceivervoltagewillbedisplayedas0V.
Viewingthereceivervoltage. Settingisunnecessary.Whenmenutelemetry
islistenedto,thevoltageappears.
Viewingthedrivebattery
voltage.
CA-RVIN-700andwiringworkarenecessary.
Usingvariousoptional
telemetrysensors.
Optionaltelemetrysensorsarenecessary.
T26SZsettingisunnecessary.
Usingseveraltelemetry
sensorsofthesametype.
Settingby"sensor"inthemenuisnecessary.
(Registerisnecessary.)
Settingalarmsfromthe
telemetryinformation.
Settingby"Telemetry"inthemenuis
necessary.
P.84
P.92
P.86
P.88
P.93 112
CAUTION
Donotstareatorsetthetransmitter
settingscreenwhileflying.
Losingsightoftheaircraftduringflightisvery
dangerous.
Whenyouwanttochecktheinformation
duringflight,callthetelemetryscreen
beforeflightandhavethescreencheckedby
someoneotherthantheoperator.
Receiver →Transmitter.Thereceptionofthesignalfrom
thereceivertothetransmitterisshown.Thisdoesnot
affectflight.

Related product manuals