16
Before Using
Digital Trim Operation
(Initial settings: DT1: Steering trim, DT2: Throttle trim, DT3: -------)
Operating by the lever: Push the lever to the left or right (up or down).
Operating by push button switch: Press the push button switch in the desired direc-
tion. The current position is displayed on the LCD screen.
Steering trim display
Throttle trim display
- Each step is indicated by a tone.
- When the trim exceeds the maximum trim adjustment
range, the tone will change pitch and the lever will not
move any farther.
- Return to the neutral position (center) by pressing both
the push button switches simultaneously for about one
second.
Trim Operation
With the center trim feature, trim adjustments have no effect on the maximum servo
travel. This prevents the linkages from binding when adjustments are made.
DT2
DT1
Lever
Push button switch
DT3
Grip dial operation
(Initial settings: DL1=Steering D/R, DL2=ATL)
Operate the dials by turning them. The current set value is displayed on the LCD
screen.
DL1
DL2
- A click sound is made at each step.
- When the maximum position is reached at each side,
the tone of the click changes. Thereafter, the set value
does not change.
ATL display
Steering D/R display
To Next Page
Loading...
