FUTABA T3PK

22
Before Using
DL1
DL2
DL3
DT1
DT2
DT3
* Function names and rate
assigned to dials are dis-
played.
* Displays whether or not a data
pack is inserted. When a data pack
is inserted, "DPAC" is displayed.
* "BLHT" is displayed when back-
lighting is ON.
* When radio waves are being emit-
ted, "RF" is displayed. When radio
waves are
not being emitted when turned on by
display switch and when the DSC
function is used, "DISP" is dis-
played.
* The current operation mode is dis-
played. ("PPM"/"PCM"/"HRS")
Display when power switch turned on
Power switch turned on
Beep confirmation sound is generated and
the initial screen shown below appears.
Total timer display (H:M)
Battery voltage display
Model name (10 characters)
* Display mode can be changed
by using the SYSTEM function.
(Page )
Steering trim display
Throttle trim display
User name display
When the (END) button is held down for 1 second or longer at the initial screen, the
Futaba logo and user name are displayed for about 2 seconds.
Total timer
The total timer shows the accumulated time from last reset.
The total time does not change even when the model changes.
Reset method
1 In the initial screen state, hold down the (+) and (-) buttons simultaneously
for 1 second.
* The total timer display counts up from 1 minute to 99hours 59 minutes.