FUTABA T3PK - Page 42

42
Functions


















TG.P=50%
TG.P=20% TG.P=80%
Adjustment method for CRV curve
(Preparation)
- Select "CRV" at setup item "FWD-TYP".
Setup items
1:~5: Curve points 1~5
C:RES : Curve reset
FWD-TYP : Forward side curve selection
BRK-EXP : Brake side rate
Setup item switching
- Use the (DN) or (UP) button to switch the setup item.
1 Curve setup
Use the (DN) or (UP) button to select "1:" (1st
point), and use the (+) and (-) buttons to set the
1st point.
Set the throttle curve by sequentially setting "2:"
(2nd point) ~ "5:" (5th point).
2 Brake adjustment
Select setup item "BRK-EXP" by pressing the
(DN) button. When you want to quicken the rise,
use the (+) button to adjust the + side and when
you want to make the rise milder, use the (-) but-
ton to adjust the - side.
3 When ending adjustment, return to the initial
screen by pressing the (END) button 3 times.
Point in current setup
A vertical cursor line that shows the
point in the current setup is displayed
on the setup screen graph.
Returning entire curve to initial value
- Select setup item "C:RES" and re-
turn the set value of each point to the
initial value by simultaneously press-
ing (approx. 1 sec) the (+) and (-) but-
tons.
For the CRV curve, only the high
side can be set. The brake be-
comes the EXP curve.
Adjustment range
1: ~ 5: 0 ~ 100%
FWD-TYP : EXP, VTR, CRV
BRK-EXP : -100 ~ 0 ~ +100%
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).