FUTABA T4PM

The function select switch
screen (page 92) can be
displayed from this screen.
< NO SW >
Displayed when the 4WS
type SW is not used.
101
Function
4WS Mixing "4WS"
1
(4WS type selection)
Select the setting item "MODE" by moving the
(JOG) button up or down. Use the (+) or (-) and
set the function to the "ON" or "OFF" state.
"
INH
"
 )XQFWLRQ2))IURQWRQO\
"
2TYP
"
)URQWVLGHRQO\UHYHUVHSKDVHVZLWFKLQJ
"
3TYP
"

)URQWVLGHRQO\UHYHUVHSKDVHDQGVDPHSKDVHVZLWFKLQJ
"
4TYP
"
)URQWVLGHRQO\UHYHUVHSKDVHVDPHSKDVHDQGUHDUVLGH
RQO\VZLWFKLQJ
:KHQ
"
*<520,;$&7
→
,1+
"
LVGLVSOD\HGWKH:6FDQQRWEHXVHGLIWKH*<
520,;IXQFWLRQLVQRWVHWWR
"
INH
"
.
:KHQ
"
%5$.(&+$&7
→
,1+
"
 LVGLVSOD\HGWKH :6FDQQRWEH XVHG LI WKH
%5$.(0,;&+IXQFWLRQLVQRWVHWWR
"
INH
"
.
Switched in the order shown in the figure below by set SW
(SW2)
.
Function ON/OFF (MODE)
OFF, 2TYP, 3TYP, 4TYP
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Rear rate (RATE)
0 ~ 100
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
2
(Rear side travel adjustment)
Select setting item "RATE" by moving the (JOG) button up or
down. Adjust the rear side travel with the (+) or (-) button.
3
(Mix mode setting)
Select setting item "MXMD" by moving the (JOG) button up or
down. Set the mix mode with the (+) or (-) button.
"
2))
"
 7KH(;3IXQFWLRQRIWKHVW&+DQGRWKHUVHWWLQJVDUHQRWPL[HG
"
21
"
 7KH(;3IXQFWLRQRWKHVW&+DQGRWKHUVHWWLQJVDUHPL[HG
4
When finished with the setting, return to the MENU screen by
pressing the (END) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.
"4TYP"
：
Front side only, reverse phase, same phase, and rear side only switching
"2TYP"
：
Front side only and reverse
phase switching
"3TYP"
：
Front side only, reverse phase, and same phase switching