FUTABA T4PM

Caution
Never try to recharge a dry cell battery.
The transmitter may be damaged or the battery electrolyte may leak or the battery
may break.
Insert the batteries in the correct polarity.
If the polarity is incorrect, the transmitter may be damaged.
When the transmitter is not in use, remove the batteries.
If the battery electrolyte leaks, wipe off the case and contacts.
Do not use commercial AA size NiCd and NiMH batteries.
Since voltage is lower than alkaline dry battery, usable
time is shortened.
Quick charging may cause the battery contacts to over-
heat and damage the battery holder.
Battery cover
6OLGHEDWWHU\FRYHUZKLOHSUHVVLQJKHUH
16
Before Using
Battery Replacement Method
1
Remove the battery cover from the transmitter by sliding it
in the direction of the arrow in the figure.
2
Remove the used batteries. Load the new AA size alkaline
dry batteries. Pay very close attention to the polarity mark-
ings and reinsert accordingly.
3
Slide the battery cover back onto the case.
Battery Replacement Method (3 AA Size Batteries)
Check:
7XUQWKHSRZHUVZLWFKRQWKHWUDQVPLWWHUWRWKH21SRVLWLRQ&KHFNWKHEDWWHU\YROWDJH
GLVSOD\RQWKH /&' VFUHHQ ,IWKHYROWDJH LV ORZFKHFN WKHEDWWHULHVIRU LQVXI¿FLHQW
contact in the case or incorrect battery polarity.
Reference:
%\FKDQJLQJWKH$$VL]HDONDOLQHGU\FHOOEDWWHULHVIURPWR\RXFDQH[WHQGWKHXVDEOHWLPH3OHDVHXVH364IRU73973/6
IRUGU\FHOOEDWWHULHVER[5HIHUWRSDJHIRUPRXQWLQJPHWKRG:KHQFKDQJLQJWRIRXUWKH$$VL]HGU\EDWWHULHVEHVXUHWRFKDQJH
WKHEDWWHU\W\SHWR&670DQGVHWWKHORZEDWWHU\DODUPYROWDJHWR9ZLWKWKH%$77VHWWLQJVHHSDJHRIWKHV\VWHPPHQX
Disposal of the Dry Cell Batteries:
7KHPHWKRGWRGLVSRVHRIXVHGGU\FHOOEDWWHULHVGHSHQGVRQWKHDUHDLQZKLFK\RXUH
VLGH'LVSRVHRIWKHEDWWHULHVLQDFFRUGDQFHZLWKWKHUHJXODWLRQVIRU\RXUDUHD
[Low Battery Alarm]
Warning
When a low battery alarm is generated, cease
operation immediately and retrieve the model.
Always replace with a new dry battery before
running next.
If the battery goes dead while in operation, you will lose
control of the model.
Blinks
If the transmitter battery voltage drops below the us-
able range, an audible alarm will sound and "
"
mark will be displayed on the LCD screen.