FUTABA T4PM

Sensor type
SBS-01T, Temp 125
Select button
- Select with the (+) or (-) but-
tons.
Display type
°C, °F
- Select with the (+) or (-) but-
tons.
Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Temperature alarm
-20~200°C/ -4~392°F
Initial value: 200°C/ 212°F
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Gear ratio (moderating ratio)
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
119
Function
(Preparation)
MODE: RX (Page 1)
Select the setting item "TEMP" by moving the (JOG) button up
or down, and display the temperature screen by pressing the
(JOG) button.
1
(Select Celsius or Fahrenheit)
Select the setting item "UNIT" by moving the (JOG) button up
or down, and select Celsius or Fahrenheit temperature display
with the (+) button or (-) button.
"
&
"
 &HOVLXV
"
)
"
 )DKUHQKHLW
2
(Setting of each item)
Select the setting item "ALRM" by moving the (JOG) button up
or down, and set alarm ON/OFF with the (+) button or (-) but-
ton.
"
2))
"
 $ODUP2))
"
21
"
 $ODUP21DWWKHVSHFL¿HGWHPSHUDWXUH
3
(Setting the temperature alarm)
Select the setting item "LIMIT" by moving the (JOG) button
up or down, and set the temperature at which the alarm
begins to sound with the (+) button or (-) button.
Select the setting item "TYPE" by moving the (JOG) button
up or down, and set the type of sensor with the (+) button
or (-) button.
"
6%67
"
 2SWLRQVHQVRU
"
7HPS
"
 2SWLRQVHQVRUIRU(XURSH
When finished with the setting, return to the TELEMETRY
screen by pressing the (END) button.
(Preparation)
MODE: RX (Page 1)
Select "R.P.M" by moving the (JOG) button up or down, and
display RPM screen by pressing the (JOG) button.
1
(Setting the RPM Gear Ratio)
Select the setting item "RATIO" by moving the (JOG) but-
ton up or down, and set the location the sensor is to actu-
ally measure and the gear ratio of the motor and engine
with the (+) button or (-) button. There is no alarm function.
When fi nished with the setting, return to the TELEMETRY
screen by pressing the (END) button.
Setting the temperature
Setting the gear ratio
Telemetry "TELEMETRY"