FUTABA T4PM

Telemetry function :OFF- Telemetry function :ON
- Receiver ID before setting or ID mis-
match.
- Telemetry function :ON
- Receiver ID setting complete
- Data receiving sensitivity display
-
shows that data cannot be re-
ceived because it is outside the data re-
ceiving range or because of the effects
of an obstruction or the receiver power is
OFF after receiver ID check.
The reception strength
No signal reception
High
Low
Receiver -> Transmitter:
The reception strength is shown.
32
Initial Set-Up
Receivers Other Than T-FHSS
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the transmitter.
3
Turn on the receiver.
4
Push the Link switch of the receiver.
When the link is complete, the LED in the receiver changes
to solid green.
The telemetry ON/OFF and communication status can be checked at the HOME screen.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver’s condition:
No signal reception Red : On
Receiving signals Green: On
Receiving signals, but ID is unmatched. Green: Blink
*1
(T-FHSS ,Red : On)
Unrecoverable failure (EEPROM,etc.) LED: Red and Green turn on alternately
 /('FRXOGEHFKDQJHWRUHGGXULQJLQWHUPLWWHQWO\GXULQJGDWDSURFHVVLQJ