FUTABA T4PM

The function select switch
screen (page 92) can be
displayed from this screen.
99
Function
Gyro mixing "GYRO MIX"
(Preparation)
- Refer to the gyro instruction manual and connect the gyro
to the receiver. When using remote gain, connect gyro sensi-
tivity adjustment to the 3rd CH of the receiver.
- When using gyro mixing by switching between the NORM
(normal) and AVCS modes, use the function select switch
function (page 92) to set the switch to be used.
1
(Gyro mixing setting)
Select the setting item "MODE" by moving the (JOG) button
up or down. Set the function by pressing the (+) or (-) button.
"
INH
"
 )XQFWLRQ2))
"
1250
"
1250$/PRGHJDLQ
"
$9 & 6
"
 $9&6PRGHJDLQ
"
6(/
"
 6ZLWFKLQJ1RUPDOPRGHDQG$9&6PRGH
 'LVSOD\HG126:!ZKHQWKH*\UR0RGH6:LVQRWXVHG
:KHQ
"
:6!2))
"
LVGLVSOD\HGWKH*<520,;FDQQRWEH XVHGLI WKH:6
function is not set to
"
2))
"
.
:KHQ
"
%5$.(&+$&7
→
,1+
"
LVGLVSOD\HGWKH*<520,;FDQQRWEH
XVHGLIWKH%5$.(0,;&+IXQFWLRQLVQRWVHWWR
"
INH
"
.
Gyro mixing adjustment
2
(NORMAL side gain adjustment)
Select the setting item "NORM" by moving the (JOG) button
up or down. Adjust the NORMAL side gain with the (+) or (-)
button.
(AVCS side gain adjustment)
Select the setting item "AVCS" by moving the (JOG) but-
ton up or down. Adjust the AVCS side gain with the (+) or (-)
button.
3
When finished with the setting, return to the MENU screen
by pressing the (END) button.
Function selection (MODE)
INH, NORM, AVCS, SEL
NORMAL / AVCS gain
(NORM / AVCS)
0 ~ 120
Initial value:30
"SELE" mode"NORM" mode "AVCS" mode
Shows the gyro mode select
switch mode.
< NO SW >
Displayed when the Gyro
Mode SW is not used.
Function SW
GYRO
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Select button
- Select with the (+) or (-) but-
tons.
Setup items
MODE: Gyro mode
NORM:
Normal mode gain
AVCS: AVCS mode gain