LINE-IN MIX MODE
You can play audio from both a connected Bluetooth device and Line-in together.
Connect external audio devices such as musical instruments and audio equipment
with “Line Level” audio to mix together with music from your Bluetooth device.
1 Follow directions to pair and connect a Bluetooth device and set G-MEGA to
Bluetooth as the audio source by pressing the BLUETOOTH PAIR Button.
2 Insert one end of the 3.5mm audio cable into the Line-In jack on the rear of
G-MEGA and other end into the Line-Out or headphone jack of your audio device.
3 Press and HOLD the LINE-IN button. Both the blue BLUETOOTH LED Indicator
and the green LINE IN LED indicator will light indicating that mix mode is active.
4 To disconnect the mix mode press and hold LINE IN button to return to
BLUETOOTH playback mode.
NOTE: To set the mix level of the relative volume from each device set the volume
from both the Bluetooth device and the device connected with Line-In. Then use the
volume control on G-MEGA to set the master volume for playback.
NOTE: This Line-In port is designed to work with Line Level audio and not “High Z”
sources with a high output impedance such as an electric guitar with passive pickups.
To Next Page
Loading...
