To Next Page

To Previous Page

Console module »DP-CON«

Computer and console modules · 179

Connection to the matrix switch

Transmission: Use a category 5e (or better) twisted pair cable to connect the Transmis-

sion interface to a Dynamic Port (RJ45) of the matrix switch.

Power supply

Main Power: Connect the power cable to the power pack and a power outlet.

Red. Power: If required, connect the power cable of the optional power pack to this

interface. This provides a redundant power supply. Connect the power cable with

the power pack and a power outlet of a different power circuit.

LED Out: If you expanded the functional range of the matrix switch by purchasing the

TradeSwitch function, connect the optional TS-LED to this interface.

Start-up

Start the console module by pressing the Main Power button of the power pack.

NOTE:

You can also connect the console module directly to a compatible computer

module.

ADVICE:

The active hotkey configuration is displayed during the System Startup of

the matrix switch.

Questions and Answers:

Need help?

Do you have a question about the G&D DVI-CPU and is the answer not in the manual?

G&D DVI-CPU Specifications

General