G&D DVI-CPU - Console Module U2-R-CON

Console module »U2-R-CON«
Computer and console modules · 191
Console module »U2-R-CON«
The U2-R-CON console module transmits USB and RS232 signals from the console to
the
U2-R-CPU computer module.
Package contents
 1 × U2-R-CON console module
 1 × Power pack (12V/2A, only with variants incl. PowerPack)
 1 × Power cable (only with variants incl. PowerPack)
 1 × »Manual information« flyer
 1 × »Safety instructions« flyer
Required accessory
 1 × Category 5e (or better) twisted pair cable to connect the console module to
the matrix switch
Installation
Connecting the console devices
RS232: Connect the serial end device to this interface.
Trans.: Use a category 5e (or better) twisted pair cable to connect this interface to the
Dynamic
Port of the USB/RS232 Main Channel that is assigned to the console.
USB 2.0 Devices: Connect up to 4 USB devices to these interfaces.
Power In: Connect the power cable to the power pack and a power outlet.
 
 
