EasyManuals Logo

Gardena SILENO minimo User Manual

Gardena SILENO minimo
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
6.3 Information and warning messages
The information messages in the table below are shown in the app. Speak to your GARDENA service if the same
message shows frequently.
Message Cause Action
Low battery
The product cannot find the charging station. Change the position of the guide wire. Refer
to
To install the guide wire on page 18
.
The battery is at the end of its life cycle. Replace the battery. Refer to
Battery on
page 29
.
The antenna of the charging station is defec-
tive.
Do a check if the indicator lamp in the charg-
ing station flashes red. Refer to
Indicator
lamp in the charging station on page 36
.
The charging plates on the product or con-
tact plates on the charging station are defec-
tive because of corrosion.
Clean the charging and contact plates using
a fine grade emery cloth. If the problem stays
speak to your approved servicing dealer.
Settings restored
A
Reset all user settings
has been done. Usual operation of the product.
Guide not found
The guide wire is not connected to the charg-
ing station.
Connect the guide wire to the charging sta-
tion. Refer to
To install the guide wire on
page 18
.
Damage in the guide wire. Replace the damaged section with new
guide wire.
The guide wire is not connected to the boun-
dary loop.
Connect the guide wire correctly to the boun-
dary loop. Refer to
To install the guide wire
on page 18
.
Loop signal created
New loop signal changed. Usual operation of the product.
Needs manual charg-
ing
The product is set to the
Secondary area
op-
erating mode.
Put the product in the charging station.
Next start hh:mm
The schedule setting prevents the product
from operating.
Change the schedule settings. Refer to
Park / Schedule on page 24
.
The product has operated the maximum cut-
ting time for the day.
Usual operation of the product.
Today's mowing
completed
The product has operated the maximum cut-
ting time for the day.
Usual operation of the product. Refer to
Park / Schedule on page 24
.
Connection NOT
changed
The loop signal was not changed because of
an error.
Make a
New loop signal
a number of times.
Refer to
New loop signal on page 22
. If the
problem stays speak to your GARDENA
service.
1585 - 002 - 08.12.2020 Troubleshooting - 35

Other manuals for Gardena SILENO minimo

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gardena SILENO minimo and is the answer not in the manual?

Gardena SILENO minimo Specifications

General IconGeneral
TypeRobotic lawn mower
Noise level57 dB
Cutting width160 mm
Grass catcher-
Product colorBlack, Blue
Maximum lawn area250 m²
Maximum cutting height45 mm
Minimum cutting height20 mm
International Protection (IP) codeIPX5
Power sourceBattery
Charging time1.25 h
Power consumption per month (max)2.1 kWh
Weight and Dimensions IconWeight and Dimensions
Depth520 mm
Width340 mm
Height220 mm
Weight6100 g

Related product manuals