GARDTEC 816 - Table of Contents

Contents
User Information ......................................................... 2
Introduction ................................................................... 3
User Code Types.......................................................... 3 - 4
Setting The System ...................................................... 6
Unsetting The System .................................................. 7
Part Setting The System............................................... 7
Area Setting .................................................................. 9
Removing Zones........................................................... 10
Testing The System...................................................... 11
Viewing The Event Log................................................. 12
Changing The Chime Status......................................... 13
Programming User Codes ............................................ 15
Programming Time & Date ........................................... 18
User Initiating Remote Access ..................................... 19
Resetting After An Alarm .............................................. 20
Setting Engineer Authorisation ..................................... 23
Mains Failure ................................................................ 25
Setting the system with Mains Fail ............................... 25
Re-setting the display after a Mains Fail....................... 26
Setting the system with Line Fault ................................ 27
System G-Tag............................................................... 28
Advanced Code Programming (Control Codes) ........... 29
Advanced Setting & Unsetting using Group Area Codes 32
Setting using Group Area Code.................................... 32
Programming Group Area User Codes......................... 33
Setting using Group Master & Group Main Codes ....... 36
Unsetting using Group Area Code................................ 37
Unsetting using Group Master & Group Main Codes ... 37
Adding Areas ................................................................ 38
Display Blanking ........................................................... 39
Keypad Alert - If Fitted .................................................. 40
Keypad Tamper ............................................................ 40
System Tampers........................................................... 40
System Attributes.......................................................... 41
Service Record ............................................................. 43
User Chart .................................................................... 44
ACE Instructions ........................................................... 45
Programming ACE Keyfobs onto your System............. 46
Page 1
GARDTEC 800 Series
User Manual
PR5893 8.qxd 22/05/2006 11:14 Page 1