Page 26
User Manual
GARDTEC
800 Series
5) Exit the premises via the authorised exit route.
6) Once the premises are secure listen (from outside
the protected area) and wait until the exit tone finishes before leaving.
Re-setting the display after a Mains Fail
Note: In the event of a Mains Power Failure, the control panel will display that a fault has occurred if the
pre-programmed time has been exceeded.
1) In the event of a mains power failure the display
will show:-
2) Enter your User code. The display will show:-
The right arrow is now indicating that more events are available for viewing.
Press the YES key to view the next event and carry on to view any others.
When viewing the last event the display will show,
for example.
The left arrow now indicates that you are at the end of events. The NO key
may be used to scroll back the opposite way.
3) Enter your User code again.The display will then
show:-
(Followed by YES if a Master or Main type code
has been used).
4) Enter the code again to abort the setting.
The display will show:-
The system is now reset.
! ! Enter Code ! !
! ! ! ! Check ! ! ! !
Power Cut FAULT
01 JAN 18 : 58 : 01->
Mains Ok Ack
01 JAN 18 : 58 : 01<-
EXIT! 1
All Zones ON 15
01 JAN 18 : 58 : 01
To Next Page
Loading...
