Page 27
User Manual
GARDTEC
800 Series
Setting the system with Line Fault
1) With the display showing:-
2) Enter your User code.
The display will then show:-
(Followed by YES if a Master or Main type code
has been used).
3) Then press NO. The display will show:-
Note: The display will switch between the EXIT display and the
Phone Line FAULT display as the time counts down.
EXIT! 1
All Zones ON 15
Phone Line FAULT
Can’t Set ! Check
! ! Enter Code ! !
! ! ! ! Check ! ! ! !
To Next Page
Loading...
