GARDTEC 816 - Unsetting Using Group Area Code; Unsetting Using Group Master & Group Main Codes

Unsetting Using Group Area Code
Follow the instructions as for normal Unsetting. When you are using a Group Area
Code only the Area(s) allocated to that code will be Unset.
Unsetting Using Group Master & Group Main Codes
1) With the display showing:-
(Areas 1 & 3 are already Set).
2) Enter a Group Master or Group Main level
Code. Display will show:-
3) Press NO. Display will show, for example:-
4) If you wish to Unset all the Areas Press YES
The system will Unset all Areas.
Or
If you wish to Unset just 1 of the Set Areas
Press NO. Display will show for example:-
(Areas 1 & 3 are Set).
5) Press the key corresponding to the Area you
wish to Unset, in this example press 3. The
display will show:-
6) Press Yes when you are happy with your
selection. Display will now show:-
Area 3 has now been Unset.
7) After 10 seconds the display will show:-
01 JAN 18 : 58 : 01
< < SET1 > >
01 JAN 18 : 58 : 01
< < SET1 3 > >
Set Area/s ?
Unset ALL Areas ?
Set 1 3
Off Ok ?
Set 1
Off = 3 Ok ?
01 JAN 18 : 58 : 01
User Manual
GARDTEC 800 Series
Page 37
PR5893 8.qxd 22/05/2006 11:14 Page 37