Garmin Forerunner 410 - Configure Your Device; Acquire Satellite Signals

Forerunner 410 Owner’s Manual 5
Getting Started
Congure Your Device
The rst time you use your device,
follow the on-screen instructions
to learn how to use the bezel, set
your user prole, and congure the
device.
If you are using an ANT+ heart
rate monitor, select  during the
conguration to allow the heart
rate monitor to pair (connect) with
your device. See page 6 for more
information.
The device uses your user prole to
calculate accurate workout data.
Acquire Satellite Signals
To set the correct time of day and
begin using the device, you must
acquire GPS satellite signals. It may
take a few minutes to acquire signals.
: To turn off the GPS receiver
and use the device indoors, see
page 19.
: You cannot acquire satellites
in power save mode. To exit power
save mode, press or .
1. Go outdoors to an open area. For
the best reception, make sure the
antenna of the device is oriented
toward the sky.
Antenna
location
2. Touch and hold  to enter
training mode.