Garmin GNS 400W User Manual

11 - MESSAGES
ABBREVIATIONS &
NAV TERMS
187
190-00356-00 Rev G
User card format unknown — A data card has been
inserted, but the format of the card is not recognized.
User Magnetic Variation is active – Note that “User” is
selectedontheAUX--Units/MagVarpageandthemag-
netic variation value provided on that page is being used.
VLOC has failed — The GNS 430W has detected a failure
initsVLOCreceiver.TheVLOCreceiverisnotavailable
and the unit should be returned to your Garmin dealer for
service.
VLOC is not responding — (GNS 430W only) Internal
system-to-system communication between the main proces-
sorandtheVLOCreceiverhasfailed.Operationalstatus
oftheVLOCreceiverisunknownandtheunitshouldbe
returned to your Garmin dealer for service.
VLOC needs service — (GNS 430W only) A failure in
theVLOCreceiverhasbeendetected.TheVLOCreceiver
may still be usable, but the unit should be returned (at your
earliest convenience) to your Garmin dealer for service.
VLOC remote transfer key is stuck — (GNS 430W
only)TheremoteVLOCtransferswitchisstuckinthe
enabled (or “pressed”) state. Try pressing the switch again
to cycle its operation. If the message persists, contact your
Garmin dealer for assistance.
VLOC transfer key stuck — (GNS 430W only) The
VLOC flip-flop key is stuck in the enabled (or “pressed”)
state. Try pressing the VLOC flip-flop key again to cycle
its operation. If the message persists, contact your Garmin
dealer for assistance.
Waypoint already exists — The name you have entered
for a user waypoint already exists in memory.
Waypoint(s) have been replaced — One or more user
waypoints were updated during a unit-to-unit crossfill
operation.
Waypoint memory is full — You have used all 1000 user
waypointlocationsinthe400W-seriesunitmemory.Delete
unwanted waypoints to make room for new entries.
Turn Advisory and Arrival Annunciations
The following annunciator messages may appear in the
lower right corner of the 400W-series unit display:
ARRIVING WPT — Arriving at the destination waypoint
for the active leg (waypoint alert).
DTK xxx° xx S — Waypoint alert. Prepare to turn to the
indicated heading upon waypoint passage.
HOLD DIRECT — “Direct”holdingpatternentry.
HOLD PARALLEL — “Parallel” holding pattern entry.
HOLD TEARDROP — “Teardrop” holding pattern entry.
LT TO xxx° xx S — Turn advisory. Turn to the indicated
heading by the time shown.
LT TO xxx° NOW — Turn advisory. Turn to the indicated
heading now.
PTK END xx S — Parallel Offset is terminating by the
time shown.
RT TO xxx° xx S — Turn advisory. Turn to the indicated
heading by the time shown.
RT TO xxx° NOW — Turn advisory. Turn to the indicated
heading now.

Garmin GNS 400W Specifications

General

Brand	Garmin
Model	GNS 400W
Category	GPS
Language	English