Garmin GPSMAP 12X3 - Wind Hold; Changing the Wind Hold Type; Engaging Wind Hold; Engaging Wind Hold from Heading Hold

Wind Hold
You can set the autopilot to maintain a specific bearing relative to the apparent or true wind angle. You must
connect a compatible wind sensor the same NMEA 2000 network as the autopilot system to perform a wind
hold or wind-based steering maneuvers.
Autopilot status information
Standby and appear in gray when the autopilot is in standby mode.
Wind Hold and appear in green when the autopilot is engaged in wind hold.
Wind gauge
Shows the true wind speed (TWS) or apparent wind speed (AWS)
Rudder position indicator
NOTE: This functionality is available only when a rudder sensor is connected.
Changing the Wind Hold Type
With the wind hold engaged, select Options > Wind Hold Type.
The wind hold type changes from Apparent to True, or vice versa.
Engaging Wind Hold
Before you can engage wind hold, you must connect a NMEA 2000 wind sensor to the autopilot.
Although a NMEA 2000 wind sensor is preferred, you can connect a NMEA 0183 wind sensor to the autopilot to
use wind hold.
1 When the autopilot is in standby mode, select Options.
2 Select an option:
• To engage an apparent wind hold, select Engage App. Wind Hold.
• To engage a true wind hold, select Engage True Wind Hold.
TIP: You can quickly engage the last type of wind hold used by selecting Wind Hold from standby mode.
Engaging Wind Hold from Heading Hold
Before you can engage wind hold, you must connect a NMEA 2000 wind sensor to the autopilot.
Although a NMEA 2000 wind sensor is preferred, you can connect a NMEA 0183 wind sensor to the autopilot to
use wind hold.
1 With heading hold engaged, select Options.
2 Select an option:
• To change from heading hold to apparent wind hold, select Engage App. Wind Hold.
• To change from heading hold to true wind hold, select Engage True Wind Hold.
Sailing Features 65