Garmin MapSource - Modifying Coverage Areas; Removing Mapsource

MapSource User’s Manual 7
INSTALLING MAPSOURCE > CHANGING OR REMOVING MAPSOURCE
Modifying Coverage Areas
Some MapSource detailed map products allow you to
modify the regional coverage areas. If your MapSource
product allows this, Modify appears as an option when
you open the MapSource InstallShield Wizard.
NOTE: You need your MapSource installation
disks to modify MapSource.
To add or remove specific coverage areas:
1. Insert the MapSource installation disk into your
computer disk drive. The InstallShield Wizard
opens. Click Next.
2. Select Modify and click Next.
3. Select the areas you want to add or remove.
Click Next.
4. Follow the additional instructions to modify
MapSource.
Removing MapSource
You can remove any MapSource product from your
computer without using the MapSource installation
disks.
To remove MapSource:
1. Click the Start button. Then select Settings >
Control Panel.
2. From the Control Panel page, select Add/
Remove Programs.
3. Highlight MapSource and click Change/
Remove.
4. Follow the instructions to remove MapSource.
OR
1. Click the Start button. Then select Programs
> MapSource > MapSource product
Installation Wizard (if enabled).
2. Click Next.
3. Select Remove.