GARO ENTITY PRO - Mount Front Cover of Charging Unit; Dynamic Load Management (DLM) Functionality

91 pages

Save Page as PDF

To Next Page

To Previous Page

Charging cable type 2 The icon is for the charging cable Type 2 that is

connected to the charging station. This means

that the charging station has a fixed cable. Only

possible for Garo Entity CS.

Type 2 outlet The icon is for the Type 2 outlet, which can be

used to charge the EV.

Installation

Main Page

Table of Contents2
Introduction5
Document Description5
Product Description5
Feature Description5
Definitions5
Intended Use6
Contact6
Safety9
Safety Definitions9
Safety Instructions for Installation9
Product Overview11
Charging Station System Overview11
Charging Station Packaging Overview12
Product Variants13
Charging Station Overview15
Dimensions16
Installation17
To Do before Installation17
Personnel Requirements17
Personal Protective Equipment17
To Do a Plan for the Installation18
To Generate the Installation Code19
To Do a Check of the Delivery19
To Ensure the Necessary Tools20
To Ensure the Necessary Installation Material20
To Decide Internet Connection Type21
To Connect Several Charging Stations21
Before Setup21
Simple Setup Scenarios22
Advanced Setup Scenarios22
To Decide the Position of the Charging Station23
Cable Installation23
To Install the Stickers for IT 230 V24
To Prepare the Installation Bracket for the Cable Installation24
To Install the Installation Bracket to a Wall25
To Prepare the Power Cable for Installation26
To Connect the Power Cable to the Terminal28
To Install a Second Power Cable (Daisy-Chaining Method)30
To Prepare the Installation Bracket with Ethernet Cable(S)30
To Prepare the Installation Bracket with a Second Ethernet Cable31
To Connect the Charging Station to the Internet with 4 G/Lte31
To Install the Control Cable to the Installation Bracket31
To Change the Position of the Type 2 Outlet or Fixed Cable32
To Do a Test of the Power Connection33
To Install a Protection Cover35
To Attach the Charging Unit to the Installation Bracket35
To Do a Final Functionality Test of the Product36
To Mount the Front Cover of the Charging Unit38
GARO Connect39
The GARO Connect App39
GARO Connect App Process Overview40
GARO Connect App Symbols Overview41
Owner44
Installer50
Dynamic Load Management (DLM)62
Dynamic Load Management (DLM) Functionality62
Dynamic Load Management (DLM) Installation Overview65
To Install the Load Interface in an Electrical Cabinet68
Operation75
To Charge an Electrical Vehicle75
Indication Light76
To Schedule Charging77
To Monitor the Charging Process77
To Stop the Charging of the Electrical Vehicle77
Maintenance79
To Clean the Charging Station79
To Do a Visual Check of the Charging Station79
To Do a Factory Reset79
To Do an Earth Fault Test79
To Do a Reset after a Minor Ground Fault80
To Do a Reset of a Circuit Breaker80
To Replace a Charging Unit80
PME - Protective Multiple Eathing (UK Versions Only)82
Service82
Repair82
Troubleshooting83
Technical Data85
Charging Station Technical Data85
Load Interface Technical Data87
Accessories88
Source Code89
EC Declaration of Conformity91

GARO ENTITY PRO - Mount Front Cover of Charging Unit; Dynamic Load Management (DLM) Functionality

Table of Contents

Other manuals for GARO ENTITY PRO