MAGNASCANNER CS 5000
OWNER S MANUAL
' 2000 GARRETT METAL DETECTORS, INC.
4/30/00
PN 11674XX
Caution: Read This Before Operating.
For best possible operation, read this manual carefully.
An optional stabilizer base, Part Number 1603900, is available and
may be used to anchor the detector. It is recommended that this base
be used in outdoor applications or where there is danger of the unit
being pushed over. Be sure to follow installation directions carefully.
Electrical requirements:
Fully automatic 100 to 240 VAC, 50/60 Hertz, 5 Watts, no rewiring or
switching required.
Compliance with Regulatory Standards requires that a Cord Set be
used for proper installation. (See page 8.)
Always place the metal detector on a level stable floor that is not sub-
ject to movement or vibration.
Do not drive nails or drill holes into the side panels.
Position away from rain, mist and condensation.
Use caution when placing the metal detector next to telephone sys-
tems, television monitors, electric motors, transformers, power
cables, or control circuits. Excessive electrical noise will show activity
on the LED bar graphs.This situation should be avoided whenever
possible.
Security type metal detectors are important tools, designed for use
within a total security screening system. It is the responsibility of the
end user to define the system and to ensure proper operation of all
aspects of the system.
To Next Page
Loading...
Need help?
General
